Publicidad
Idiomas disponibles
Idiomas disponibles
CUTTING CROWN MOLDING FLAT ON THE
TABLE (FIG. 41):
a. Move the sliding fence to the proper position.
b. Set the bevel and miter angles using the
Chart in this section. Tighten the miter-lock
lever and the bevel-lock lever.
c. Position the molding on the saw table. Clamp
the workpiece in place with the work clamp.
WARNING
operation. Before switching on the saw, lower
the head assembly to make sure that the clamp
clears the guard and the head assembly.
d. Activate the main switch. Lower the head
assembly and make your cut.
e. Wait until the blade comes to a complete
stop before returning the head assembly
Key
Miter Setting
A
31.6° Right
B
31.6° Left
C
31.6° Left
D
31.6° Right
Use a clamping position
that does not interfere with
Bevel Setting
33.9° Left
33.9° Right
33.9° Right
33.9° Left
Fig. 41
38°
Wall
to the raised position and/or removing the
workpiece.
NOTICE: Always make a test cut using scrap to
confirm that the angles are correct.
Inside corner-Left side
1. Position top of molding against fence.
2. LEFT side is finished piece
Inside corner-Right side
1. Position top of molding against fence.
2. RIGHT side is finished piece
Outside corner-Left side
1. Position top of molding against fence.
2. LEFT side is finished piece
Outside corner-Right side
1. Position top of molding against fence.
2. RIGHT side is finished piece
-40-
Celling
52°
A B
Inside Conner
Fence
Miter Table
Type of Cut
C
D
Outside
Conner
Publicidad
