Flex FX7141A Manual Del Operador página 18

After the dust bag is 2/3 to 3/4 full, remove
it from the saw. Bring the bag to a proper
container and pull open the zipper located on
the bottom of the bag. Hold the bag by the
coupler end and shake it vigorously until all the
dust and debris fall from it. Close the zipper
and reattach the bag.
NOTICE: Clean the bag at the end of the
cutting session and before transporting or
storing the saw.
WARNING
in fine particle form may be explosive. Do
not throw sawdust on an open fire.
Spontaneous combustion may, in time, result
from mixture of oil or water with dust particles.
WARNING
assembly, adjustment or repair to avoid
possible injury.
HEAD ASSEMBLY LOCK PIN (FIG. 6)
The head assembly lock pin is used to hold the
head assembly in the DOWN position.
This position prevents the head assembly from
moving up and down during transportation and
makes the saw more compact for lifting and
storage. This position is also required for some
adjustment procedures.
To engage the head assembly lock pin:
a. Ensure that the depth-stop function is not
engaged.
b. Grasp the main handle and press down on
the head assembly.
c. While holding the head assembly down,
push the head assembly lock pin to the right.
Release the head assembly and it will be
locked in the DOWN position.
Be extremely careful with
disposed dust. Materials
ADJUSTMENTS
Remove the battery pack
before performing any
Fig. 5b
Vacuum
Adapter
Fig. 6
Head Assembly
Lock Pin
To disengage the head-assembly lock pin:
a. Grasp the main handle and press down on
the head assembly.
b. While holding the head assembly down, pull
out the head assembly lock pin. Release the
head assembly lock pin while maintaining
your grip on the main handle. Slowly allow
the spring-loaded head assembly to come
up to the top of its travel and then release the
handle.
-18-