Publicidad
Idiomas disponibles
Idiomas disponibles
6.
Fitting and removing the
wheel
WARNING – Wheel slip!
Risk of crushing of fingers and other body
parts when attaching and removing wheel.
¶
Wear protective gloves.
¶
Wear safety shoes.
¶
Do not place fingers between the wheel and
the shaft.
¶
Heavy wheels should always be handled by
two people.
6.1
Securing the wheel
1. Switch on the SBM V85 A with the On/Off switch.
2. Position a suitable cone on the shaft (flange).
Fig. 15:
Positioning the appropriate cone on the shaft (flange)
3. Use a wire brush to remove any dirt.
4. Place wheel on shaft directly on the cone.
5. Push the unlocked quick-action clamping nut onto
the shaft and press firmly against the wheel.
Fig. 16:
Sliding the (disengaged) quick-locking nut onto the shaft
SICAM srl soc. Unip
Fitting and removing the wheel | SBM V85 A | 43
6. Release the lock and turn the quick-action clamping
nut clockwise until the wheel is firmly braced.
Fig. 17:
Turning the quick-locking nut in the clockwise direction
"
The wheel is secure.
i
For a good quality balancing, it is necessary to
carefully tighten the quick locking ring nut.
6.2
Removing the wheel
1. Turn the quick-action clamping nut anti-clockwise
and release the wheel.
2. Unlock and take off the quick-action clamping nut.
3. Remove the wheel.
en
|
1 695 600 571
2016-08-23
Publicidad
