Publicidad
Idiomas disponibles
Idiomas disponibles
104
3. Oil tank
With a wire hook, remove the oil filter through the oil fill hole and clean it with gasoline. When
replacing the film covering the tank, make sure it gets to the right front corner. Clean the dirt from
the tank.
4. Plug
5. Gear
Examine the gear for any signs of cracks or excessive wearing a hat may
affect the movement of the chain. If there is an obvious wear, replace the
sprocket. Never fit a new chain on a worn sprocket, or a worn chain on a
new sprocket.
6. Front and rear shock absorbers
Change these parts when the parts adhered are separated or when observed cracking in the rubber
part. Replace if the inside of the metal rear shock if it is beaten by the bolt and if the game of the
metal is increasing.
MAINTAINING THE SAW CHAIN AND THE GUIDE BAR
SAW CHAIN
WARNING
For many reasons of safety and proper operation of the unit, it is extremely
important that the teeth are constantly sharpened.
WARNING
The teeth need to be sharpened:
• When the sawdust has the appearance of dust.
• When you need extra force to saw.
• When the cutting path is not straight.
• When the vibration increases.
• When you increase the fuel consumption of the unit.
Clean the electrodes of the spark plug using a wire brush.
Verify that the separation between electrodes is 0.6-0.7 mm
and make adjustments as necessary.
Publicidad
