Publicidad
Idiomas disponibles
Idiomas disponibles
98
5. Once ignition occurs, press the throttle to enter, to the first position again and pull the
starter rope to start the engine.
6. Let the engine warm up keeping the throttle slightly pulled.
WARNING
Avoid close contact with the chain of the saw, as it begins to move once the engine
starts.
Before starting the engine, run the chain at medium speed and verify that a spill of oil as shown in
the illustration.
OIL SUPPLY CONTROL
WARNING
Be sure to place the bar and chain to verify the deputy minister of oil. Otherwise,
the rotating parts will be exposed, which is very dangerous.
After starting the engine, run the chain at medium speed and verify that a spill of oil as shown in the
illustration.
Oil flow to the chain could be changed by inserting a screwdriver into the hole located on the bottom
side of the clutch. Make the adjustment for working conditions.
NOTE
The oil tank should be almost empty to run out of fuel. Be sure to fill the oil tank
every time you refuel.
ADJUSTING THE CARBURETOR
The carburetor of this unit has been factory set.
However, in some cases it may be necessary to make minor adjustments to
changes in the conditions of use. Before attempting to make adjustments to the
carburetor, check the air filters and fuel are correct.
1) Needle ¨"L"
(2) Needle "H"
(3) Screw idling
Chain oil
Publicidad
