Stertil Koni ST 4032 Instrucciones Para El Uso página 32

4
4.1 General
1. (Emergency)main switch
2. Raise
3. Lower
4. Lower by interlock
5. Slowly lower
6. Selector switch wheel free
system (optional)
4.2 Switching-on
4.3 Raising
4.4 Lower
4.5 Lowering into safety
catch
Operating instructions (Version B)
Operation
Place the vehicle straight on the vehicle lift, with the tyres completely on the
tracks. Apply the handbrake and place stop blocks in front of the wheels.
Operation of the vehicle lift is effected through buttons on the control panel (see
Figure 4.1) which is mounted on post III. Also refer to the operation sticker on
the vehicle lift.
2
3
4
Figure 4.1 Control panel
Note
n
Only use finger tips to operate the control panel. Do not use sharp
objects (such as screwdrivers) to operate the control panel as this can
cause damage and breakdown.
The buttons used to raise, lower normally and lower by interlock are of the dead
man type (i.e. hold to run). Operation is only possible while such buttons remain
depressed and will stop immediately when the button is released.
Switching-on the vehicle lift is carried out as follows:
1. Turn the main switch (1) to position 1.
This connects the mains power supply and the control voltage.
2. The vehicle lift is now ready for use.
Press button (2) to raise the vehicle lift. There is an upward pointing arrow next
to this button.
To lower the vehicle lift, use buttons (4) <unlock> and (3) <lower> at the same
time. During lowering, the <unlock> button (4) can be released. The safety
pawls will remain in the open position.
Warning
w
If there is any problem during lowering, release the button immediately.
To lower into safety catch, only press the button (4) at the bottom right. The
vehicle lift will then lower by a max. of 60 mm until the safety catches engage
with the locking profiles.
32
6
1
5
ST 4032 / ST 4040
4