Stertil Koni ST 4032 Instrucciones Para El Uso página 37

5
Operating instructions (Version B)
Inspection and maintenance
To change the hydraulic oil, carry out the following procedure:
1. Set the vehicle lift to the lowest position and drain off the oil.
2. Fill the tank with hydraulic oil HYDRAN 46 (46 cSt / 40°C), filtered at 4
micron max.
Table 5.2 Hydraulic oil
Model
Capacity
Warning
w
Use only approved oil in the reservoir. An incompatible oil may damage
or totally destroy the seals of the hydraulic cylinders, pump, and valves.
This could cause a serious safety hazard.
Warning
w
Do not check or add oil when the lift is in the raised position. An overflow
condition may the result. Needless damage could occur to the lift
components.
5.3.3 Lighting armatures (option)
Note
n
Clean the lighting armatures only with a non aggressive cleaning agent.
37
ST 4032 / ST 4040
8 l
ST 4032 / ST 4040