Trumpf TruTool N 350 Manual Del Usuario página 17

2.2 Noise and vibration information
WARNING
Hearing damage if noise emission
value is exceeded
Wear hearing protection.
u
WARNING
Danger of injury if vibration emis-
sion value is exceeded
Select tools correctly and change
u
promptly in case of wear.
Specify additional safety measures to
u
protect the operator against the effect
of vibrations (e.g. keep hands warm,
organization of work processes, pro-
cessing with normal feed force).
Depending on the conditions of use and con-
dition of the power tool, the actual load can
be higher or lower than the specified mea-
surement.
The specified vibration emission value was
measured according to a standardized test
process and can be used to compare power
tools. It can also be used for a preliminary
estimation of the vibration load.
Times when the machine is switched off or is
running, but not actually in use, can signifi-
cantly reduce the vibration load during the
entire working period.
Translation of the original operator's manual
3 Operation
ATTENTION
Property damage due to twisting of
the power tool
Cut curves at a low feed rate.
u
Do not fall below the power tool's mini-
u
mum radius.
Before processing the workpiece, coat
u
the cutting track with oil to improve the
cutting results and increase the service
life of the wearing parts.
Only apply the power tool to the work-
u
piece once it has reached full speed.
u If the cutting line ends within the work-
piece: Guide the power tool a few mil-
limeters backwards at full speed.
Only switch the power tool off when the
u
cutting process is finished.
ATTENTION
Property damage due to too-low
nominal power
If an isolating transformer is used, the
u
isolating transformer must have a nom-
inal power of at least 3 kVA.
To operate the power tool, see:
– Switching on and off
– Setting the speed
– Setting the cutting direction
– Turning the motor handle
– Setting the immersion depth
– Slitting workpieces
– Slitting interior cut-outs
EN
[} 315].
A
[} 315].
B
[} 315].
C
[} 316].
D
[} 316].
E
[} 316].
F
[} 316].
G
17