Trumpf TruTool N 350 Manual Del Usuario página 18

EN
3.1 Slitting interior cut-outs
For slitting interior cut-outs, a starting hole
(d) must be drilled, see Slitting interior cut-
outs [} 316].
G
N 350 N 500
(3A1) (3A1)
d 30 mm 41 mm
3.2 Slitting with template
h
a
a Distance between contour of the tem-
plate and contour of the workpiece
h Template thickness
r Minimum template radius
s
When slitting with a template, the following
minimum dimensions must be heeded:
N 350 N 500
(3A1) (3A1)
a 5.5 mm 8.5 mm
h 4 mm 3 mm
r 12.5 mm 110 mm 160 mm
s
18
N 700 N 1000
(2A1) (3B1)
60 mm 75 mm
r
s
N 700 N 1000
(2A1) (3B1)
11 mm 15.5 mm
5 mm 5 mm
330 mm
Translation of the original operator's manual
3.3 Cutting radii
When cutting radii, the minimum interior
radius (r ) must be heeded:
min
N 500
(3A1)
r 90 mm 140 mm
min
N 350
(3A1)
It is possible to turn on the spot with
this power tool. Therefore, no minimum inte-
rior radius (r ) must be heeded.
min
3.4 Reducing the speed
N 350 N 500
(3A1) (3A1)
With these power tools, the
speed can be reduced quickly in the follow-
ing situations:
– Cutting after scribing
– Cutting radii
– Cutting high-strength materials
3.5 Changing gears
N 1000
(3B1)
For higher processing speed, the
power tool can be switched into second
gear, see Changing gears
The gear can only be changed after switch-
ing off the power tool, the motor runs on at
low speed.
The following maximum material thicknesses
must be heeded when changing gears:
Steel
2
up to 400 N/mm
Steel
2
up to 600 N/mm
Aluminum
2
up to 250 N/mm
N 700 N 1000
(2A1) (3B1)
300 mm
[} 316].
H
Material thickness
1st gear 2nd gear
10 mm / 8 mm /
0.394 in 0.315 in
7 mm / 5 mm /
0.276 in 0.2 in
12 mm / 10 mm /
0.472 in 0.394 in