Ingeteam INGECON SUN 10TL M2 Manual De Instalacion Y Uso página 33

AC connection
9. AC connection
This chapter explains the requirements and process for connecting the AC wiring to the unit.
Read carefully before starting the connection process.
INFO
Consult section "Important safety instructions"
For further information about the connection of the inverter within the installation, please see section
Electrical diagram of the system".
9.1. Safety instructions for the AC connection
DANGER
Make sure there is no voltage present in the unit and that the DC connection has not been made before starting
the AC connection.
Do not switch on the powerto the unit until you have successfully made the rest of the connections.
Use the Personal Protective Equipment specified in the section
Respect the polarity of the AC wiring.
CAUTION
Ingeteam accepts no liability for any damages caused by an incorrect connection.
The communications for this inverter are also powered from the AC section.
9.2. Wiring requirements for the AC connection
A
A (Diameter)
B (Cross-section)
C (Length)
D (Length)
E (Length)
F (Diameter)
G (Diameter)
Terminal tightening torque
To guarantee the safety of persons, for the unit to function correctly and comply with the applicable standards, the
unit must be connected to the ground of the installation.
ACL2012IQM01_ - Installation and Operation Manual
and the following instructions before working on the unit.
"Personal Protective Equipment
D
B
10TL M2 15TL M2
11 ~ 18 mm
4 ~ 6 mm (recommended 6 mm
2
E + 2 mm
100 millimeters
According to terminal
M4
<10 mm
1.5 Nm
(PPE)".
C
E
20TL M2
24 ~ 32 mm
6 ~ 16 mm (recommended
2
)
2
10 mm
M5
<12.5 mm
3 Nm
Ingeteam
"2.7.
F
G
2 )
EN
ES
FR
IT
PT
33