Publicidad
Idiomas disponibles
Idiomas disponibles
Using the dryer.
Always follow fabric manufacturer's
care label when laundering.
Sorting
and Loading
Hints
As a general rule, if clothes are sorted
properly for the washer,they are sorted
properly for the dryer. Try also to sort items
according to size.For example, do not dry
a sheet with socks or other small items.
Do not add fabric softener sheets once
the load has become warm. They may
cause fabric softener stains. Bounce®
Fabric Conditioner Dryer Sheets have
been approved for use in this dryer when
used in accordance with the manufacturer's
instructions.
See below for lint filter cleaning instructions.
Do not overload. This wastes energy and
causes wrinkling.
Do not drg the following items: fiberglass
items, woolens, rubber-coated items, plastics,
items with plastic trim and foam-filled items.
Fabric Care Labels
Below are fabric care label "symbols" that
affect the clothing you will be laundering.
Dry Labels
N rb-lrOq
dry
Dry
Normal
Permanent Press/
wrinkle resistant
Do not dry
Gentle/
De net tumble dry
(used with
delicate
do not wash)
setting
High
Medium
Low
0
No heat/air
I=1 Iml
instructions
Line dry/
Drip dry
hang to dry
Dry flat
Fq
In the shade
12
Care and Cleaning
of the Dryer
Drger Interior and Duct: The interior of
the appliance
and exhaust duct should be
cleaned once a gear by qualified service
personnel.
The Exterior: Wipe or dust any spills or
washing compounds
with a damp cloth.
Dryer control panel and finishes may be
damaged
by some laundry pretreatment
soil and stain remover products. Apply
these products away from the dryer. The
fabric may then be washed and dried
normally. Damage to your dryer caused
by these products is not covered by your
warranty.
Do not touch the surface or the display
with sharp objects.
The Lint Filter: Clean the lint filter before
each use. Remove by pulling straight up.
Run your fingers across the filter. A waxy
buildup may form on the lint filter from
using dryer-added fabric softener sheets.
To remove this buildup, wash the lint
screen in warm, soapy water. Dry
thoroughly and replace. Do not operate
the dryer without the lint filter in place.
Vacuum the lint from the dryer lint
filter if you notice a change in dryer
performance.
Stainless Steel: To clean stainless steel
surfaces, use a damp cloth with a mild,
nonabrasive cleaner suitable for stainless
steel surfaces. Remove the cleaner
residue, and then dry with a clean cloth.
The stainless steel used to make
the dryer drum provides the highest
reliability available in a GE dryer. If
the dryer drum should be scratched or
dented during normal use, the drum
will not rust or corrode. These surface
blemishes will not affect the function
or durability of the drum.
The Exhaust Hood: Check with a mirror
that the inside flaps of the hood move
freely when operating. Hake sure that
there is no wildlife (birds, insects, etc.)
nesting inside the duct or hood.
Publicidad
