Publicidad
Idiomas disponibles
Idiomas disponibles
ge.com
PROBLEM
Time Remaining
jumped to a
lower number
Possible Causes
The estimated time may change
when a smaller load than usual
is drying
What To Do
• This is normal.
Cannot make a
selection and the
dryer beeps twice
The DRYNESS LEVEL,TEMP
or OPTIONthat you are
trying to select is incompatible
with the chosen dry cycle
This is normal.
Dryer is running but
O0is displayed in
Time Remaining
The EXTENDTUMBLE
option was chosen
This is normal. During extended tumbling, the time
remaining is not displayed. The extended tumbling
option lasts approximately 20 minutes.
Clean Lint Filter (message)
POWER button was activated
• PressSTART/PAUSEto begin a dry cycle and the message
will disappear.
Dryer doesn't heat
Fuse is blown/circuit b reaker
istripped; the dryer may tumble
but not heat
Check the building's fuse/circuit breaker box and
replace both fuses or reset both breakers.Your dryer
may tumble if only one fuse is blown or one breaker
tripped.
Gas service isoff
• Make sure gas shutoff at dryer and main shutoff are
fully open.
LP gassupply tankis empty
orthere hasbeena utility
interruption
ofnatural g as
(gasmodels)
Refillor replace tank. Dryer should heat when utility
service is restored.
Inconsistent
drying times
Typeofheat
Type ofload and
dryingconditions
Drying time will vary according to the type of heat used.
If you recently changed from an electric to a gas
(natural or LP)dryer, or vice versa, the drying time
could be different.
• The load size,types of fabric, wetness of clothes and the
length and condition of the exhaust system will affect
drying times.
Glow at the rear
of the drum
Heaters behind the drum
• This is normal. Under certain drying conditions and
room ambient lighting, the glow of the heaters may be
visible at the rear of the drum.
Clothes are still wet
and dryer shut off
after a short time
The door was opened mid-cycle.
The load was then removed from
the dryer and a new load put in
withoutselecting a new cycle
• A dry cycle must be reselected each time o new load
is put in.
Small load
• When drying 3 items or less,choose SPEEDDRYor
TIMEDDRY.
Load was already dry except
• Choose SPEEDDRY or TIMED DRYto dry damp collars
for collars and waistbands
and waistbands. In the future, when drying a load with
collors and waistbonds, choose MOREDRY.
Dryer is not level
• Move dryer to an even floor space or adjust leveling legs
as necessary until even.
Clothes are wrinkled
Overdrging
• Select a shorter drying time.
Removeitems while they still hold a slight amount of
moisture. Select a LESS DRY or DAMP setting.
Letting items sit in dryer after
• Removeitems when cycle ends and fold or hang
cycle ends
immediately, or use the EXTENDTUMBLEoption.
Overloading
• Separate large loads into smaller ones.
45
Publicidad
