Publicidad
Idiomas disponibles
Idiomas disponibles
Installation
Instructions
CONNECTING
A GAS DRYER (cont.)
GAS REQUIREMENTS
WARNING
Installation
must conform
to local codes
and ordinances,
or in their absence, the
NATIONAL FUEL GAS CODE, ANSI Z223.
• This gas dryer is equipped with a Valve and
Burner Assembly for use only with natural gas.
Using conversion
kit 14-A048, your local service
organization
can convert this dryer for use with
propane (LP) gas. ALL CONVERSIONS MUST BE
MADE BY PROPERLYTRAINED AND C.)UALIFIED
PERSONNEL AND IN ACCORDANCE WITH LOCAL
CODES AND ORDINANCE REQUIREMENTS.
• The dryer must be disconnected
from the gas
supply piping system during any pressure testing
of that system at a test pressure in excess of
0.5 PSI (3.4 KPa).
The dryer must be isolated from the gas supply
piping system by closing the equipment
shut-off
valve during any pressure testing of the gas
supply piping of test pressure equal to or less
than 0.5 PSI (3.4KPa).
DRYER GAS SUPPLY CONNECTION
12%"
(6.7 om_308T"F?PAddlEoT;2;t_2_AS SUPPLY
dimension t hedistance between
cabinet bottom to floor.
GAS SUPPLY
• A 1/8" National Pipe Taper thread plugged
tapping, accessible for test gauge connection,
must be installed immediately
upstream
of the
gas supply connection
to the dryer. Contact your
local gas utility should you have questions on the
installation
of the plugged tapping.
• Supply line is to be 1/2" rigid pipe and equipped
with an accessible shutoff within 6 feet of, and in
the same room with, the dryer.
• Use pipe thread compound
appropriate
for
natural or LP gas or use Teflon ® tape.
• Connect flexible metal connector
to dryer and
gas supply.
IN THE COMMONWEALTH
OF MASSACHUSETTS
• This product must be installed by a licensed
plumber or gas fitter.
• When using ball-type
gas shut-off valves, they
shall be the T-handle type.
• A flexible gas connector,
when used, must not
exceed 3 feet.
18
Publicidad
