Publicidad
Idiomas disponibles
Idiomas disponibles
Installation
Instructions
STACKINGTHE WASHER AND DRYER(if desired} (cont.)
[_] INSTALL BRACKET TO DRYER
A,
B,
Align the holes in the left bracket with the holes
in the bottom
left corner of the drger. Use a
Phillips screwdriver
to install the 2 #12 x 1"
tapping screws.
Repeat the above step with the right bracket
on the bottom
right corner of the drger.
C. Set the drger upright.
NOTE: Make sure to set the drger on a piece of
packing material so the brackets that are attached
to the bottom
of the drger do not damage
the floor.
ioi
i
[]
INSTALL DRYER AND BRACKET
ON WASHER
A,
Lift the drger on top of the washer. Be careful
not to scratch the top of the washer with the
brackets. Protect the washer control panel with
cardboard
or other protection.
Be sure to lift
the drger high enough to clear the washer
control panel.
_ZIWARNING - Potential
Personal
Injury.
More than two people are
recommended
to lift the dryer into position
because of its weight
and size. Failure to do
so could result in personal
injury
or death.
B. Align the holes in the bracket with the holes
in the back of the washer. Using a Phillips
screwdriver,
attach the 2 #8 x 1/2" tapping
screws. Repeat on both sides of the washer.
/
r_ FINALIZE THE INSTALLATION
A. Refer to the washer Installation
Instructions
to complete
the washer installation.
B,
C,
Refer to the drger Installation
Instructions
to complete
the drger installation.
Carefullg slide or walk the stacked washer and
drger into place. Use felt pads or other sliding
device to assist moving and to protect flooring.
-A WAR N IN G - Potential Personal
Injury.
Do not push on the dryer
once installed
to top of the washer.
Pushing on the dryer
mag
result in pinched fingers.
Place
___"
hands
here_
00°
tl:
Place
hands
"_-here
4O
Publicidad
