Publicidad
Idiomas disponibles
Idiomas disponibles
Installation
Instructions
STACKING THE WASHER AND DRYER (if desired)
BEFORE YOU BEGIN
Read these instructions
completely
and carefully.
•
IMPORTANT-
Save these instructions
for local electrical
inspector's
use.
• IMPORTANT-Observe all g overning
codes and ordinances.
• Note to Installer
- Be sure to leave these
instructions
with the Consumer.
• Note to Consumer
- Keep these instructions
for future reference.
• Service must be performed
by a qualified
installer.
• Proper installation
is the responsibility
of
the installer.
FOR YOUR SAFETY:
WARNING
-
Electric Shock Hazard. Disconnect
power before
installing.
Failure to do so could result in serious
injurg or death.
Potential
Personal
Injurg. More than two people
are recommended
to lift the drger into position
because of its weight
and size. Failure to do so
could result in personal
injurg or death.
Avoid Tipping and Rupture of UtilitLI Services.
DrLler must be securelg attached
to the washer.
DO NOT place the washer on top of the drger.
Failure to do so could result in personal
injurg/death
or propertLI damage.
Mobile Home or Manufactured
Home
Installation
- Stacking of a gas drger is not
permitted
in a mobile home or manufactured
home.
MINIMUM
CLEARANCE OTHER THAN
ALCOVE OR CLOSET INSTALLATION
Minimum clearance
to combustible
surfaces
and for air opening are: 0" both sides, 1" front
and 3" rear. Consideration
must be given to provide
adequate
clearance
for installation
and service.
REQUIREMENTS FOR ALCOVE OR
CLOSET INSTALLATION
• Your drLler is approved
for installation
in
an alcove or closet, as stated on a label on
the drger back.
• The drLler MUST be vented to the outdoors.
See
the EXHAUSTING THE DRYERsection.
• Minimum
clearance
between drger cabinet and
adjacent walls or other surfaces is:
0" either side
3" front and rear
• Minimum vertical
space from floor to overhead
shelves, cabinets, ceilings, etc., is 52".
• Closet doors must be Iouvered or otherwise
ventilated
and have at least 60 square inches
of open area equallg distributed.
If the closet
contains both a washer and a drLler, doors must
contain a minimum
of 120 square inches of open
area equallg distributed.
• The closet should be vented to the outdoors
to prevent gas pocketing
in case of gas in the
supplg line.
• No other fuel-burning
appliance
shall be
installed in the same closet with the drger
(gas models onlg).
NOTE: WHEN THE EXHAUST DUCT IS LOCATED AT
THE REAR OF THE DRYER, MINIMUM CLEARANCE
FROM THE WALL IS 5.5 INCHES.
38
Publicidad
