Fronius Selectiva 4.0 Serie Manual De Instrucciones página 11

If this is the case, then the operating company is obliged to take appropriate ac-
tion to rectify the situation.
Data backup The user is responsible for backing up any changes made to the factory settings.
The manufacturer accepts no liability for any deleted personal settings.
Maintenance Before each start-up, check the mains plug and mains cable and charging cables
and charging terminals for damage.
If dirt accumulates on the device, clean the surface of the device housing with a
soft cloth and only with solvent-free cleaning agents.
Repair Repair work must only be carried out by authorized personnel. Use only original
spare and wearing parts (also applies to standard parts). It is impossible to guar-
antee that third-party parts are designed and manufactured to meet the de-
mands made on them, or that they satisfy safety requirements.
Do not carry out any alterations, installations, or modifications to the device
without first obtaining the manufacturer's permission.
Obligations of The operating company must only allow persons to work with the device if they:
the operating -
company
-
-
The safety-conscious work of the personnel must be checked regularly.
Safety Inspec- The manufacturer recommends that a safety inspection of the device be per-
tion formed at least every 12 months.
A safety inspection by a certified electrician is recommended
-
-
-
-
For the safety inspection, follow the appropriate national and international
standards and guidelines.
You can obtain more information about the safety inspection from your service
center. The service center will provide the necessary documents upon request.
Markings on the
Devices bearing the CSA label satisfy the essential requirements of applicable
device directives.
Disposal Waste electrical and electronic equipment must be collected separately and re-
cycled in an environmentally sound manner in accordance with the European Dir-
are familiar with the basic occupational safety and accident prevention regu-
lations and are trained in handling the device,
have read and understood these Operating Instructions, especially the
"Safety rules" section, and have confirmed this with their signature,
are trained according to the requirements for the work results.
after changes,
after alterations,
after repair, service and maintenance,
at least every 12 months.
11