Timken VHIN-G3-35 Manual De Instrucciones página 20

6.5 Explanation of system settings – screen 4
Min. speed alarm:
Min. speed:
T hold hysteresis:
System info:
T hold hysteresis is the setting that belongs to T hold in the set up (heating) screen.
6.6 Explanation of system settings – screens 5 and 6
In this screen, the system date and time can be set.
Depending on whether you want to use the ΔT functionality, switch on "ΔT enabled".
Only when you switch on "ΔT enabled", another screen is available in which you can enter the
desired settings for this functionality.
20
Alarm if insufficient temperature increase is measured according to the
Min. speed limit setting.
Minimum temperature gradient.
Temperature at which the workpiece may be lowered before the heating
process restarts automatically.
Information about firmware versions.