Publicidad
Idiomas disponibles
Idiomas disponibles
8.2 Heating a horizontal workpiece
•
This is only possible if the bore of the workpiece is large enough to fit over the pole.
•
Place the workpiece as centrally as possible around the pole on the horizontal supports.
•
The workpiece may not be wider than the horizontal supports.
•
Always choose the largest induction yoke.
•
Make sure that the bare-metal sides are sufficiently coated with acid-free grease to ensure
optimal contact and avoid vibration.
•
Always make sure that the workpiece does not come into contact with the plastic casing of the
heater.
•
When the heating is finished, follow the instructions in reverse order. Use heat-resistant gloves
to move the heated workpiece.
8.3 Maximum weights
Table for maximum permitted weights on the horizontal support and the (swivel) yokes:
On
Type
supports
VHIN-G3-35
50 kg
VHIS-G3-75
100 kg
VHIS-G3-100
150 kg
VHIS-G3-150
200 kg
VHIS-G3-200
400 kg
VHIS-G3-400
600 kg
VHIN-G3-600
800 kg
VHIN-G3-800
1600 kg
•
Keep to these maximum weights and avoid tilting the heater or damaging the supports,
(swivel) yokes or hinge.
NOTE!
•
Always handle induction yokes with care. They are damaged easily when dropped, knocked
against something, etc. Store them immediately after use.
7
10
14
20
1 kg
2 kg
3 kg
5 kg
-
2 kg
3 kg
5 kg
-
-
-
10 kg
-
-
-
10 kg
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
Size of (swivel)yokes (mm)
30
40
50
10 kg
15 kg
-
10 kg
15 kg
20 kg
15 kg
25 kg
40 kg
45 kg
15 kg
25 kg
40 kg
45 kg
-
-
-
60 kg
-
-
-
60 kg
-
-
-
-
-
-
60
70
80
90
-
-
-
-
-
-
-
-
50 kg
-
-
50 kg
-
-
-
80 kg
-
-
-
80 kg
-
-
-
-
-
-
-
-
25
EN
DE
ES
FR
NL
Publicidad
