Timken VHIN-G3-35 Manual De Instrucciones página 32

Only when sensors are connected, the heating process is displayed graphically by pressing the info
button . Pressing info again displays additional information from the process.
•
During heating, the pre-set time counts down to 00:00. When 00:00 is reached, the induction
heater switches off. The workpiece is then demagnetised automatically and a loud, continuous
beep sounds. Press "STOP" to switch off the beep.
9.4 Heating in temperature or time mode
•
Position the workpiece and sensor (according to chapters 7 & 8.)
•
Switch on the heater and select the temperature or time mode if necessary.
•
If necessary, change the temperature and/or time set by pressing the current values.
•
Press "START". The heating starts, you will hear a slight humming sound.
•
The display shows the temperature and the time left until process completion.
32