Timken VHIN-G3-35 Manual De Instrucciones página 24

8.1 Heating a hanging workpiece
•
Place the induction yoke with the bearing on the poles. Make sure that the bare metal side is
positioned straight on the poles.
•
Always choose an induction yoke that fills the bore of the bearing as much as possible. You can
even use 2 yokes at the same time. This promotes optimal, fast and even heating.
•
Make sure that the bare-metal sides are sufficiently coated with acid-free grease to ensure
optimal contact and avoid vibration.
•
Swivel arm models: swivel the yoke open (towards you) until it clicks in the safety positioning
cam. Slide the workpiece over the yoke until it is in the middle. Swivel the yoke back to the pole.
•
Always make sure that the workpiece does not come into contact with the plastic casing of the
heater. When the heating is finished, follow the instructions in reverse order. Use heat-resisant
gloves to move the heated workpiece.
24