•
Remove tool keys and other adjustment tools before switching on the machine.
•
Keep the area around the machine free of obstacles (e.g. dust, chips, cut parts, etc.).
•
Check the strength of the machine connections before each use.
Never leave the running machine unattended. Switch off the machine before leaving the
•
working area and secure it against unintentional or unauthorised recommissioning.
•
The machine may only be operated, serviced or repaired by persons who are familiar with it
and who have been informed of the hazards arising from this work.
•
Ensure that unauthorised persons maintain a safe distance from the machine and keep
children away from the machine.
•
When working on the machine, never wear loose jewellery, loose clothing, ties or long, open
hair.
Hide long hair under hair protection.
•
•
Wear close-fitting protective clothing and suitable protective equipment (eye protection,
dust mask, ear protection; gloves only when handling tools).
Metal dust can contain chemical substances that can have a negative effect on health.
•
Work on the machine should only be carried out in well-ventilated rooms. If necessary, use
a suitable extraction system.
If there are connections for dust extraction, make sure that they are properly connected
•
and in working order.
•
Always work with care and the necessary caution and never use excessive force.
Do not overload the machine!
•
Shut down the machine and disconnect it from the power supply before carrying out any
•
adjustment, conversion, cleaning, maintenance or repair work. Before starting any work on
the machine, wait until all tools or machine parts have come to a complete standstill and
secure the machine against unintentional restarting.
•
Do not work on the machine if it is tired, not concentrated or under the influence of
medication, alcohol or drugs!
Do not use the machine in areas where vapours from paints, solvents or flammable liquids
•
represent a potential danger (danger of fire or explosion!).
15.5
Electrical safety
Make sure that the machine is earthed.
•
Only use suitable extension cords.
•
•
Proper plugs and sockets reduce the risk of electric shock.
•
The machine may only be used if the power source is protected by a residual current circuit
breaker.
Before connecting the machine turn the main switch to position "0".
•
15.6
Special safety instructions for this machine
•
Clamp the workpiece firmly before switching on the grinding wheel.
•
To avoid bruising, keep 600 mm of space outside the end position of the machine and
prohibit all other persons from entering this area while the machine is in operation.
•
Always close all guards and the cabinet cover when not maintaining the machine.
Ensure that the maximum permissible peripheral speed of the grinding wheel is 35 m/s or
•
higher.
•
Only use grinding wheels that are matched to the workpiece and pay special attention to
the instructions of the grinding wheel manufacturer (limits of use, conditions, etc.).
•
Before use, the grinding wheel must be checked for possible cracks by means of a sound
test. If there is the slightest suspicion of damage, it must not be used again!
Balance the grinding wheel before mounting. Only have the grinding wheel balanced by a
•
trained employee. Before mounting the grinding wheel on the spindle, clean the contact
surface between the flange and the front end of the spindle.
Check the spindle for correct direction of rotation.
•
Clean the surface of the magnetic chuck before use, if the surface has scratches or scars,
•
regrind it carefully.
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
SAFETY
41
FSM25AUTO