Descargar Imprimir esta página

HOLZMANN MASCHINEN FSM25AUTO Instrucciones De Servicio página 49

Rectificadora de superficies

Publicidad

Idiomas disponibles

Idiomas disponibles

16. Without resetting the Emergency Stop button, press the grinding cycle start button. The
machine must not start.
If this is the case, the safety function of the Emergency Stop button is guaranteed. Continue
with the next step.
However, if the machine starts with the Emergency Stop button pressed in, disconnect the
power supply to the machine immediately. The Emergency Stop button does not function
properly. In this case contact the customer service.
17. Turn the Emergency Stop button clockwise until it pops out.
18. Turn on the coolant pump on the operation display. After checking that the coolant flows
out of the nozzle, switch the coolant pump off again.
The retraction must be carried out at the lowest speed. Let the machine run at this speed for about
20 min. Pay attention to any abnormalities and/or irregularities, such as unusual noises, unbalance,
etc. If everything is OK, gradually increase the speed with the control lever speed X-axis and the
potentiometer table travel Y-axis.
If unusual noises or vibrations occur during the test run, stop the machine immediately and read
the troubleshooting section. If you cannot find a remedy, contact your specialty retailer or
customer service.
18.3
Operating the machine
18.3.1
Switching on the machine
Note that the machine can only be started if:
The EMERGENCY STOP is unlocked
The grinding wheel guard is closed
The grinding table guard is closed
The cover of the cabinet is closed; and the limit switches are activated
18.3.2
Operation display
START PAGE:
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
N O TE
To switch on the machine, turn the main switch to position ON.
By keying the symbol on the operation display on "PREPARE
PAGE" the hydraulic pump is switched on.
Select language:
• Key
• Key
• Key
to select ENG
to select POL
to select RUS
OPERATION
49
FSM25AUTO

Publicidad

loading