Publicidad
Idiomas disponibles
Idiomas disponibles
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
NOTE:
Keying RISE UP POINT raises the grinding
wheel by the entered value
• Set rough grinding times e.g.: 5
The number of finished operations is displayed
in the right field
• Set rough feedrate e.g.: 0,010mm
• Set fine grinding times e.g.: 2
The number of finished operations is displayed
in the right field
• Set fine feedrate e.g.: 0,005mm
• Set spark out times e.g.: 2
• Switch on or off the automatic travel of Y-
axis with key OPEN(on)/CLOSE(off) on
"PREPARE PAGE"
• Set grinding wheel to starting position
• Key Single grinding mode
• Set travel X-axis with the adjustment cams
(1)
• The direction of travel is changed after
switching the direction valve (2)
NOTE:
Set the travel so that the grinding wheel
is outside the workpiece before the change of
direction!
• Set travel Y-axis with the adjustment cams
(1)
• The direction of travel is changed after
switching the limit switches (2)
NOTE:
Set the travel so that the grinding wheel
is outside the workpiece before the change of
direction!
• Set selector switch manual | automatic (1) to
automatic mode
• Start grinding cycle by pushing the grinding
cycle start button (1) or key START on
"WORK PAGE".
OPERATION
52
FSM25AUTO
Publicidad
