HTW EON -S026EON-R32 Manual De Usuario E Instalacion página 66

USER AND INSTALLATION MANUAL
7. INSTALLATION
7.10 WIRE CONNECTION
1. Indoor unit (fig.12)
• Open the panel upwards and open directly to the maxi-
mum.
• Open the electrical cover.
• Secure the connection wires to the terminal block accor-
ding to the wiring diagram on the electrical cover.
• Press the connecting wire tightly with the pressure
plate.
• Close the electrical cover, secure the electrical cover
with screws, and close the panel.
Note: Some models may not be able to directly pass through the cable hole into the electric control box, and
the above steps need to be removed after removing the middle frame.
2. Outdoor unit (fig.13)
• Unscrew the handle cover fixing screw and open the
handle cover.
• Secure the connection wires to the terminal block accor-
ding to the wiring diagram on the handle cover.
• Press the connecting wire tightly with the pressure plate.
• Put the handle cover back and fasten with the screws.
• If customers need to extend or replace the power cord,
please refer to Table 3 for specifications.
Table 3
Model
HTW-S026EON-R32
HTW-S035EON-R32
HTW-S052EON-R32
66

Maximum length (m)
20
20
25
Screw
Maximum height (m)
15
15
15
SPLIT 1X1 EON
Electric cover
Wiring diagram
Open
Close
Fig.12
Handle cover
Wiring
diagram
Fig.13
Additional load >5g/m
15
15
15