golmar Stadio Plus Manual De Instalación página 101

100
P
rogramming the monitors.
In case of a general entrance door panel, program the monitors only from each internal
building door panel, as described on the corresponding instruction manual.
If this door panel is installed on an internal building of a residential complex or on a single
building, program the monitors as follows:
golmar
For Platea Plus monitors:
Each apartment must have one master unit only; in case of parallel units configure them
as slaves, both monitors or telephones.
MONITOR PROGRAMMING
To enter the door panel into program mode, press
13:15
Switch off the monitor to be programmed.
Once the monitor is off, press the door release push button.
With the door release push button pressed
switch on the monitor.
To show that the system is ready for programming, the panel
will reproduce a sound and the LCD will display the
message
on the monitor. At this moment, the door release
push button can be released. Lift the handset to stablish
audio communication with the door panel.
key symbol and enter the installer PIN code
(factory default: 1315), as described on page 83.
, appearing the picture
program mode
Enter the code of the monitor to be
programmed and press the bell key.
At this moment the panel will reproduce
a sound and the monitor led will blink.
To program the monitor as master, switch it
off and on again.
To program it as slave, press the door
release push button.
To program it as slave with intercom
function press the push button.