MONITOR PROGRAMMING
P
rogramming the monitors.
For Platea Uno monitors:
Each house must be equipped with just one main unit; if parallel-conected units exist,
they must be configured as slave, whether monitors or phones.
For both monitors:
Turn off the monitor to be set, by pressing the door opener
button during 1 second.
Once it has been turned off, press the autoswitch-on button.
Keep the autoswitch-on button pressed and without releasing it,
press the door opener button.
The doorpanel will produce tones to indicate that the
device is ready to be set up.
The monitor will show the image and it will be possible
to release the other buttons.
Lift the handset from the monitor.
Make a call to make sure that the monitor has been properly programmed.
Program the other monitors in the same way.
At the end of the program process, exit the configuration menu by pressing
the CANCEL key. If you forget to do this, the doorpanel will exit
automatically the menu after 90 seconds.
Enter the code of the monitor to be
programmed and press the bell key.
At this moment the panel will reproduce
a sound and the monitor led will blink.
To set up the monitor as the main one,
hang the handset up.
To set up the monitor as a slave one,
press the door opener button.
101