golmar Stadio Plus Manual De Instalación página 85

84
Coming from previous page
configuration
english
*
master panel
*
general panel
*
panel address
modify value
panel address
*
panel w. camera
DOORPANEL PROGRAMMING
To enter into configuration menu, follow
the steps described on the previous page
and press OK when the display shows the
message
Allows to choose the language of the displayed
messages and the programming menues.
To choose a different language press OK
until the desired language will be displayed.
Each system must have one master panel only;
the rest of panels must be slave.
yes
In systems with general entrance panel
configure as master one panel of each
internal building.
Press OK to change this value.
If this panel is a general entrance door panel
select YES.
yes
Press OK to change this value.
Sets the building code. In buildings with
more than one panel, set them with the
:000
same code; in systems with general entrance
panel, set 0 code for the general entrance
panel and a different code for each internal
panel (valid codes are from 1 to 255).
To change this value press OK: the display
will show the message
:000
Key in the new building code and confirm
by pressing OK.
If CANCEL is pressed the former value
will be restored.
:015
If this panel is a video door panel select YES.
Press OK to change this value in case of
yes
audio door panel only.
C
onfiguration menu.
.
CONFIGURAtION
modify value
Continue
.