golmar Stadio Plus Manual De Instalación página 98

MONITOR ADJUSTMENTS
E
l562 module for video installations with twisted pair cable.
H
andling the end of line jumper.
C
hanging the front film (only Platea PLUS).
The Platea PLUS monitor is supplied with a reversible front film, that allow
the owner to choose between two colors.
To change the front film, remove the front plate by inserting a plain screwdriver
in the triangle marks, as it is shown on the drawing.
Platea PLUS: Locate the CN4 connector, that's placed in the monitor
base. Remove the existing jumper and plug the EL562 module.
Platea UNO: Locate the CN2 connector, that's placed in the monitor
base. Remove the existing jumper on the connector and the JP1
jumper on the right.
NOTE: refer to the specific installation diagram
The end of line jumper is placed on the CN4 connector (CN2 on
Platea UNO), that can be located on the monitor base.
In case of twisted pair cable installations, the end of line jumper
is placed in the EL562 module, also located in the CN4 connector
(CN2 on Platea UNO) of the monitor base.
Do not remove the jumper on monitors where the video cable finishes.
Remove the jumper on monitors where the video cable continues.
97