Publicidad
Idiomas disponibles
Idiomas disponibles
-
Make sure all parts and components are included and in good conditions. If there is any
piece missing or in bad conditions, contact the official Cecotec Technical Support Service
immediately.
Box content
-
Oven
-
Baking tray
-
Rack
-
Air fry basket
-
Pizza tray
-
Instruction manual
3. INSTALLATION
To ensure the correct operation of the appliance, make sure the piece of furniture is suitable
for built-in installation. Figure 3 shows the dimensions of the cut-out for installation under the
worktop or in a high cabinet.
-
To ensure adequate ventilation, the rear panel of the cabinet must be removed. It is
preferable to install the oven so that it rests on two wooden slats. If the oven rests on a
flat surface, there must be an opening of at least 45×560 mm, like shown in figure 4.
-
Adjacent cabinet panels shall be made of heat-resistant material. In particular, enclosures
with a veneered exterior must be assembled with glues that can withstand temperatures
up to 100 ℃.
-
In compliance with current safety regulations, it must not be possible to come into contact
with the electrical parts of the oven once it has been installed.
-
All parts that ensure the safe operation of the appliance must only be removed with the
aid of a tool.
-
To fix the oven to the cabinet, open the oven door and fix it by inserting the 4 wood screws
into the 4 holes on the perimeter of the frame.
Electrical connections
Ovens equipped with a three-pole power cable are designed to operate on alternating current.
The earth wire of the appliance is yellow green.
Mounting the power cable
Fig. 5
-
Open the terminal board:
-
With a screwdriver, tighten the screw on the side tabs of the terminal board cover.
-
Unscrew the screws on the side tabs of the cover and remove the latter.
BOLERO HEXA AF314500 GLASS BLACK A / MATT A
ENGLISH
55
Publicidad
