Kratki PATIO Manual Del Usuario página 34

should only be carried out by authorized gas appliance installers or authorized service tech-
nicians in accordance with the applicable regulations; the above should be confirmed on the
product warranty card. Lack of such confirmation voids the warranty!
INSTALLATION OF THE EQUIPMENT AND STORAGE OF THE CYLINDER SHOULD BE COMPATIBLE
WITH THE APPLICABLE LAW REGULATIONS.
The device has an open combustion chamber without the option of connecting it to a flue duct. The
PATIO heater is sold with a pre-installed gas control system, but before using it for the first time it is
advisable to check the tightness of the system for possible leakage occurred in transport. All instruc-
tions for proper connection of the system, installation of walls, doors and glazing can be found below.
REMARKS ON THE TRANSPORT OF THE DEVICE:
This device is equipped with wheels for its easy transport. Before moving the heater, make sure all
the wheel brakes are unlocked, the gas supply is cut off and the door is closed. If the unevenness
or slope of the surface is significant, remove the gas cylinder before moving the heater for your
own safety and transport the cylinder separately. Transporting the device while it is in operation
is strictly forbidden. Once the heater is located in the desired position, lock the brakes on at least
two of its wheels.
RULES FOR INSTALLATION
Installation should be carried out in accordance with national or regional law. In the absence of such
regulations, the rules in this manual and the fire safety codes must be followed.
This device has been tested for quality and safety and certified by a notified body.
CAUTION!
The heater is designed to work with an 11-kilo gas cylinder designed to store a mixture of propane-
-butane gas. Flexible connecting pipe should be used for LPG! The device is sold with complete
automation and cables connecting the main and the control burners to the controller. Do not use
replacement parts other than those installed or supplied by the manufacturer.
CHOOSING THE LOCATION OF THE PATIO GARDEN HEATER
The PATIO gas garden heater is a mobile device that can be moved to any selected location. Howe-
ver, there are certain restrictions that must be strictly applied. The device should be kept away from
flammable materials due to high temperatures on its external surfaces, especially glasses; due to open
combustion chamber without the possibility of connecting to flue gas ducts the device should be
used in open spaces or in well ventilated rooms. IT IS ABSOLUTELY PROHIBITED to place the device in
other than vertical position.
Tips for correct and safe installation:
• Connect the reducer to the liquid gas cylinder so that the tilting valve is in upright position. Connec-
ting it in another way can block the gas supply to the device. Use the appropriate tools to carry out
these activities. Tightening the reducer by hand only is insufficient and may result in gas leakage.
Replacement and/or connection of the cylinder should take place in well ventilated areas.
• Before connecting the reducer remember to ensure that the rubber gaskets are in place and are not
damaged. If this is not the case, the device cannot be used until the gasket is replaced.
• Keep in mind that the gas cylinder should always be in upright position and that the connecting
cable between the cylinder and the burner should run in the manner so as not to come in contact
with sharp objects or edges or the hot parts of the burner.
• Check the correct operation and tightness of the installed gas control system as well as the entire gas
34