Kratki PATIO Manual Del Usuario página 38

CAUTION!!!
The remote control should always be kept out of the reach of children and other persons who are
unaware of the consequences of their actions.
CAUTION!!!
Never use tools to change the position of the knobs. Changes to the position of the knobs can
only be made manually; otherwise the controller may be damaged. Contact a service technician
if the knobs are locked.
The PATIO heater uses modern B6R-H9 remote controls set in accordance with the European standard
to 868 MHz radio frequencies. The remote control does not require a new transmission code and is
ready for use. When replacing the remote control, a pairing procedure is required. To pair the new
remote with the heater, first press and hold the RESET button, located on the receiver housing, until
you hear two characteristic signals, then release the button. This activity should be carried out using a
thin, blunt element. Then, press and hold the remote control button until you hear two short beeps
which mean synchronizing the remote control with the receiver. One long signal indicates that the
system components were paired not correctly. Figure 9.
INFORMATION
To view the current version of the software used by the remote control, simultaneously press the
and . Simultaneous pressing the button and the button will display the remote control model.
Deactivating the remote control.
Install batteries. All available icons will appear on the display and will flash. During the flashing, press
the appropriate icon for the function and hold it for 10 seconds. The icon appropriate for the selected
button will flash until the end of the deactivation process. The remote control display shows the icon
adequate for the selected function and two horizontal lines. If the function is deactivated two hori-
zontal lines will appear on the display when pressing the button responsible for its selection. After
replacing batteries, the settings will remain unchanged.
Activating the remote control.
Install batteries. All available icons will appear on the display and will flash. Press the appropriate icon
for the function and hold it for 10 seconds. The icon appropriate for the selected button will flash
until the end of the activation process. The remote control display shows the icon adequate for the
selected function.
NOTE!!!
If, when you try to light it, the control flame goes out, wait for at least five minutes before trying
again to light the fireplace.
NOTE!!!
If, after four attempts to light the fireplace, the control flame will not ignite, close the gas shut-
-off valve to the appliance and contact your service representative.
38