La Pavoni LPSDIG03 Manual De Uso página 30

few millimetres into the milk.
• Turn the steam knob (7) anticlockwise
and slowly move the container
upwards to obtain a creamier froth.
• Once the volume of milk has
doubled, immerse the frothing nozzle
completely and heat the milk.
• Stop the steam by turning the steam
knob (7) clockwise.
Danger of burns! Spurts of hot
water may be ejected when you
first start to dispense steam. The
nozzle can become extremely hot.
Do not touch it directly with your
hands.
After heating the liquid, it is
recommended that you purge the
steam pipe by opening the valve
for a few seconds.
6. CLEANING AND MAINTENANCE
WARNING:
This appliance must not be
immersed in water for cleaning
6–1. CLEANING THE STEAM AND HOT
WATER NOZZLES
• To avoid altering the taste of the
drinks to be heated and to prevent the
holes at the end of the nozzles from
becoming clogged, clean thoroughly
with a damp cloth after each use and
dispense a small amount of steam.
6–2. CLEANING THE GROUP HEAD AND
SHOWER SCREENS
• Remove the filter holder from the
group head and clean the group's
gasket using the brush (16) provided.
• Place the blind filter (27) provided in
the filter holder (25-26).
• Add a spoonful of coffee machine
cleaning powder and insert the filter
holder into the group head.
• Use the lever (15) to start dispensing;
stop dispensing after approximately
15-20 seconds.
• Start and stop delivery several times
until clean water is dispensed, in
order to remove coffee and limescale
deposits.
• Remove the filter holder (24) and start
dispensing several times in order to
rinse the group head and eliminate
any residues from the shower screens
and the group head.
If the machine has not been used
for a long time, we recommend
that you allow water to flow out to
remove any deposits.
6–3. CLEANING THE FILTERS AND
FILTER HOLDERS
• Regularly check the holes in the
filters in order to remove any coffee
deposits.
• Place approximately one litre of
boiling water and four teaspoons of
coffee machine cleaner in a suitable
container. Immerse the filters and
filter holders in the solution for 20-30
minutes. Then rinse thoroughly under
running water.
6–4. CLEANING THE OUTSIDE OF THE
MACHINE
To keep the outer surface of the coffee
machine in good condition, it should
be cleaned regularly after use. Let the
appliance cool down first. Clean with a
soft, damp cloth.
6–5. REPLACING THE GROUP HEAD
GASKET (Fig. 8)
If coffee leaks from around the edges of
the filter holder (L) when it is dispensed,
it may be due to an obstruction in the
delivery hole of the filter-holder, in
26