Publicidad
Idiomas disponibles
Idiomas disponibles
• Press "+" button for 2 sec., motor will automatically start it's travel learning.
• During gate closing, the indicator lights will be on from L5 to L1 in sequence
and repeatedly.
• During gate opening, the indicator lights will be on from L1 to L5 in sequence
and repeatedly.
• After travel is set, the indicator lights L1-L5 will be on in sequence, then all will
flicker once and go off.
NOTE:
• If there is no operation under the limit switch position setting for 60 sec.,
system will automatically exit the setting.
• If need to exit during setting, press "PROG" once to exit.
REMOTE CONTROL MANAGEMENT
a) Standby mode
b) Single-button mode learning
c)
Three-button mode learning
d) Pedestrian mode on remote control
e) Remote control delete
Operation instruction:
• Press "-" button for 2 sec. under standby mode to enter into the first function
of remote control management.
• Different functions can be selected through "+" and "-" buttons.
• Press "SET" button to enter into the corresponding parameter settings.
Remote control mode instruction:
NOTE: There are two modes available for remote control under this control board.
Users may pair the remote control in their required mode.
• Single button mode: Open/Stop/Close of the gate opener is controlled by only
one button on the remote control.
• Three button mode: Open/Stop/Close of the gate opener is controlled by three
different buttons on the remote control.
EN
Publicidad
