Publicidad
Idiomas disponibles
Idiomas disponibles
• Plug the power cord into an approved RCD protected weatherproof outlet.
• Remote controls included in this kit are factory paired ready for use.
• Ensure gate opener is installed and the sliding gate is in the middle position
(see left picture above), limit switch stops are correctly installed and well
contacted with magnetic limit switch.
• The ideal closed final position for the gate frame is 10-15mm from closed gate
end catch.
3.4.
Cleaning and maintenance
a)
Unplug the mains plug before each cleaning, adjustment or replacement of
accessories, or if the device is not being used.
Wait for the rotating elements to stop.
•
b)
Always unplug the device before cleaning it.
c)
Use only non-corrosive cleaners to clean the surface.
d)
Store the unit in a dry, cool place, free from moisture and direct exposure to
sunlight.
e)
Do not spray the device with a water jet or submerge it in water.
f)
Do not allow water to get inside the device through vents in the housing of
the device.
g)
The device must be inspected monthly to check its proper operation and spot
any damage.
EN
Publicidad
