Publicidad
Idiomas disponibles
Idiomas disponibles
EN
Stopping the mower
Depress the clutch/brake pedal until the unit
■
stops.
Mowing
In normal mode
/
■
tion lock): Before reversing the machine, switch off
and raise the cutter deck.
In reverse mowing mode
■
ation, ignition lock): Exercise extreme caution
when reverse mowing and do not activate unless
absolutely necessary.
Do not change direction when the mower is
■
coasting or driving.
Start the engine as indicated.
■
To ensure adequate power output, move the
■
throttle (if fitted) to
Release the parking brake: Fully depress clutch/
■
brake pedal, push lever to a speed setting.
Move the direction-of-travel lever to "F"/ forwards.
■
Switch on the cutter deck:
■
- Switch on PTO
Lower the cutter deck.
■
Slowly release the clutch/brake pedal, the unit
■
moves off.
Emptying the grass catcher
If there are clippings left on the floor:
Stop the mower.
■
Actuate the parking brake.
■
Switch off the cutting mechanism.
■
Fig. 6a
Pull grass catcher upwards using the rear handle
■
and empty.
or
Fig. 6b
Stop the engine and wait until all moving parts
■
have come to a standstill.
Remove the grass catcher.
■
Empty out the contents.
■
Re-attach the grass catcher.
■
General
When adjusting the cutting height and travel speed,
ensure that the mower is not overloaded. To ensure
problem-free mowing, the cutting height and driving
speed must be adjusted according to the length,
type and moisture of the clippings. If blockages
occur, reduce the driving speed and increase the
cutting height.
Switching the device off
Stop the mower.
■
Step on the brake pedal and actuate the parking
■
brake.
Switch off and raise the cutter deck.
■
Set throttle (if fitted) to the middle position.
■
14
(see Operation, igni-
(see Oper-
.
.
After 20 seconds, set ignition key to
■
Remove the ignition key.
■
Note
Leave engine to cool down before placing
the mower in an enclosed space.
Accessories (optional)
Risk of injury from the cutter
Wear safety gloves.
Mowing with side discharge
Fig. 7
Accessories: Discharge flap (c)
Move cutting height adjustment lever to "1" (cutter
■
deck down).
Remove discharge chute (b).
■
Attach discharge flap (c).
■
Mulching
Accessories: Mulching blade and locking part
(Fig. 8)
Have accessories fitted by a technician (tightening
torque = 122 Nm).
Install the locking component as illustrated in Fig. 7.
Note
Due to the safety interlock system, the grass
catcher (a, Fig. 7) must also be attached
when mowing with side discharge or when
mulching.
Tips on lawn care
Here are some tips to help you keep your lawn look-
ing healthy and ensure uniform growth.
Mowing
A lawn is made up of various different types of
grass. If you mow more frequently, the grown of
strongly-rooting grasses is favoured resulting in firm
turf. If you only rarely cut the grass, you will encour-
age the development of high-growing types of grass
and other weeds, such as clover and daisies.
The normal height of a lawn is approx. 4-5 cm. Only
1/3 of the total height should be mown; therefore
cut 7–8 cm long grass to normal height. Preferably
do not cut the lawn shorter than 4 cm, otherwise the
turf will be damaged in a dry period. If the grass has
grown particularly high (e.g. during a holiday period),
cut it back to its normal height in stages.
Tips on lawn care
.
Publicidad
