Publicidad
Idiomas disponibles
Idiomas disponibles
Programming (continued)
NOTE: Please obtain the latest Installation Manual by search the model number at liftmaster.com.
SELECT DOOR SETTINGS
SECTIONAL DOORS
STANDARD, HIGH LIFT AND VERTICAL
1.
To select Door Hanging, Cable Drum (and Sprocket JHDC/ JDC) settings, navigate to the SYSTEM SETTINGS >
DOOR SETTINGS submenu.
2.
Select The Drum Type. Correct Drum Types are required for the correct door profile to run the system.
a.
Standard Lift choices: D400-96, D400-144, D5250-18, D525-216, D800-384**
b.
Full Vertical choices: D850-132, D1100-216, D1350-336
c.
High Lift choices: 48° HL, D400-54, D525-54, 60° HL: D575-120, 144° HL: D6375-164
3.
Sprocket FOR JHDC / JDC (ONLY) If you have a different sprocket size, use Custom option to add your tooth
sprocket.
700lb operators - Standard Lift, High Lift and Full Vertical 22 tooth sprocket recommended
1200lb operators – Standard Lift, High Lift and Full Vertical 22 tooth sprocket recommended
2200lb operators – Standard Lift, High Lift and Full Vertical 32 tooth sprocket recommended (Vertical with D1350-
336 – 42 tooth sprocket recommended)
Any other tooth configuration, please use Custom Option and enter your sprocket info.
ROLLING DOOR
1.
Select Rolling Door
2.
Select Insulated or Non-Insulated Door Type
3.
Select Height (increment of 2')
a.
8', 10', 12', 14', 16', 18', up to 28'
4.
Select Width (increment of 2')
a.
8', 10', 12', 14', 16', 18', up to 28'
5.
Select Sprocket (SKU dependent, please reference page 4)
a.
Sprocket choices: 50, 60, 72, 82, Custom
IMPORTANT: Once you choose your drum, allow inverter parameter to update. Once the inverter is updated, you can
re-enter the menu to set limits and learn force.
SET LIMITS
IMPORTANT: When setting limit positions, it is important that the door runs in the direction of the intended limit.
Example: When setting the close limit, only use the CLOSE button. When setting the open limit, only use the OPEN
button. Using the opposite direction button will cause the limit positions to drift over time.
To set limits, navigate to the SYSTEM SETTING > DOOR POSITIONS submenu.
DOOR
DOOR
POSITION
POSITION
OPEN LIMIT
MID-STOP
This operator allows for the programming of a single mid-stop door position.
6.
To set the open mid-stop position:
7.
In Programming Mode, go to Door Position => Open Mid-Stop or Close Mid-Stop.
8.
Use the Up/Down buttons to move the door to the desired position.
9.
Select Save = Enter
10.
To erase the mid-stop, select Erase Open Mid-Stop or Erase Close-Mid Stop option, then select Save=Enter.
NOTE: Restoring defaults or resetting limits will erase the mid-stop position.
DOOR
DOOR
POSITION
POSITION
CLOSE
OPEN MID-
LIMIT
STOP
DOOR
POSITION
CLOSE MID-
STOP
30
DOOR
DOOR
POSITION
POSITION
RMV OPEN
RMV CLOSED
MID
MID
Publicidad
