VALBERG FBI 16S43 A XAD929C Instrucciones De Uso página 10

Idiomas disponibles

Using the appliance

1.Take away the four short screws

Step 3. Dishwasher installation steps

NOTE

Please refer to the specific installation steps in the

installation drawings.

1. Install the furniture door to the outer door of the dishwasher. (Step 2 to Step 5)

2. Adjust the tension of the door springs by using an Allen key turning in a clockwise motion

to tighten the left and right door springs. Failure to do this could cause damage to your

dishwasher. (Step 6)

3. Affix the condensation strip under the work surface of cabinet. Please ensure the

condensation strip is flush with edge of work surface. (Step 8)

4. Connect the inlet hose to the cold water supply. (Step 9)

5. Connect the drain hose. (Step 9)

2.Pin up the four long screws

Using the appliance

6. Connect the power cord. (Step 9)

7. Place the dishwasher into the cabinet. (Step 10)

8. Level the dishwasher. The rear foot can be adjusted from the front of the dishwasher by

turning the Philips screw in the middle of the base of dishwasher use a Philips screw driver.

To adjust the front feet, use a flat screw driver and turn the front feet until the dishwasher

is level. (Step 11)

9. The dishwasher must be secured in place. The fixed operation is as follows:

Step 4. Levelling the dishwasher

Dishwasher must be level for proper dish rack operation and wash performance.

1. Place a spirit level on door and rack track inside the tub as shown to check that the

dishwasher is level.

2. Level the dishwasher by adjusting the three levelling feet individually.

3. When level the dishwasher, please pay attention not to let the dishwasher tip over.

NOTE

The maximum adjustment height of the feet is 50 mm.

978526