Publicidad
Idiomas disponibles
Idiomas disponibles
B
Using the appliance
Changing the program mid-cycle
• A program can only be changed if it has been running only for a short period of time,
otherwise the detergent may have already been released or the the wash water with
detergent has already been drained. If this is the case, the dishwasher needs to be reset and
the detergent dispenser must be refilled.
To reset the dishwasher, follow the instructions below:
1. Open the door a little to pause the cycle, after the spray arms stopped working you can
open the door completely.
2. Press Program > button for more than three seconds, the dishwasher will be in program
selection mode.
3. You can change the program to the desired cycle setting.
4. Close the door, the dishwasher will restart to run.
3 sec
Forget to add a dish
A forgotten dish can be added any time before the detergent dispenser opens. If this is the
case, follow the instructions below:
1. Open the door a little to stop the washing.
2. After the spray arms stopped working, you can open the door completely.
3. Add the forgotten dishes.
4. Close the door.
5. The dishwasher will start running again.
36
EN
B
Using the appliance
WARNING
It is dangerous to open the door mid-cycle, as hot steam
may scald you.
Auto Open
At the end of a program the door will open automatically to achieve better drying effect and
reduce energy use during the drying phase. Rapid and self-cleaning programs don't have
this function.
NOTE
The dishwasher door must not be blocked when set to open
automatically. This can disrupt door lock functionality.
Activ'Door is a technology that opens doors at the end of a cycle. This means that residual
steam in the tank can escape, rather than being deposited on the dishes. This system
optimizes drying while limiting energy consumption. At the same time, this will reduce the
amount of residue on your dishes.
There's a button to deactivate the Activ'Door. Automatic door opening can operate on all
programs except the short programs (i.e. the quick program and the soaking program, if
present on your appliance). The automatic opening function can be activated or deactivated
by pressing the door opener button.
37
EN
Publicidad
