Publicidad
Idiomas disponibles
Idiomas disponibles
C
C
Useful information
Useful information
Problem
Possible causes
Wrong detergent.
Foam in the tub
Spilled rinse aid.
Detergent with colourant may
Stained tub interior
have been used.
White film on inside surface
Hard water minerals.
The affected items are not
corrosion resistant.
A program was not run after
There are rust stains on cutlery
dishwasher salt was added.
Traces of salt have gotten into
the wash cycle.
The lid of the softer is loose.
Knocking noise in the
A spray arm is knocking against
dishwasher
an item in a basket
Rattling noise in the
Items of crockery are loose in
dishwasher
the dishwasher.
48
What to do
• Use only the special
dishwasher detergent to avoid
suds. If this occurs, open
the dishwasher and let suds
evaporate. Add 1 liter of cold
water to the bottom of the
dishwasher.
• Close the dishwasher door,
then select any cycle. Initially,
the dishwasher will drain out
the water. Open the door after
draining stage is complete
and check if the suds have
disappeared.
• Repeat if necessary.
• Always wipe up rinse aid
spills immediately.
• Make sure that the detergent
has no colourant.
• To clean the interior, use
the damp soft cloth with
dishwasher detergent and wear
rubber gloves. Never use any
other cleaner than dishwasher
detergent for the risk of
foaming or suds.
• Avoid washing items that are
not corrosion resistant in the
dishwasher.
• Always run a wash program
without any crockery after
adding salt. Do not select the
Turbo function (if present), after
adding dishwasher salt.
• Check the softener lid is
secure.
• Interrupt the program and
rearrange the items which are
obstructing the spray arm.
• Interrupt the program,
and rearrange the items of
crockery.
EN
C
C
Useful information
Useful information
Problem
Possible causes
This may be caused by on-site
Knocking noise in the water
installation or the cross-section
pipes
of the piping.
The dishes were not loaded
correctly.
The program was not powerful
enough.
Not enough detergent was
dispensed.
The dishes are not clean
Items are blocking the
movement of the spray arms.
The filter combination is not
clean or is not correctly fitted in
the base of wash cabinet. This
may cause the spray arm jets
to get blocked.
Combination of soft water and
Cloudiness on glassware.
too much detergent.
White spots appear on dishes
Hard water area can cause
and glasses.
limescale deposits.
Aluminium utensils have
Black or grey marks on dishes
rubbed against dishes
Dishes block detergent
Detergent left in dispenser
dispenser
49
What to do
• This has no influence on
the dishwasher function. If
in doubt, contact a qualified
plumber.
• See "Preparing And Loading
Dishes".
• Select a more intensive
program.
• Use more detergent, or
change your detergent.
• Rearrange the items so that
the spray can rotate freely.
• Clean and/or fit the filter
correctly. Clean the spray arm
jets.
• Use less detergent if you have
soft water and select a shorter
cycle to wash the glassware
and to get them clean.
• Check water softener settings
or fill status of salt container.
• Use a mild abrasive cleaner
to eliminate those marks.
• Re-loading the dishes
properly.
EN
Publicidad
