Corghi A 2024 Manual De Uso página 21

UNPACKING / ASSEMBLY
WARNING
Take the utmost care when unpacking, assem-
bling, and setting up the machine as described
in this heading.
Failure to observe these instructions can lead
to damage to the machine and injury to the
operator or other persons.
- Remove the upper part of the packing and
make sure that the machine has not suffered
damage in transit; identify the points at which
the machine is anchored to the pallet.
- The machine comprises fi ve main sections
(fi g.1):
1 tower
2 tower guard
3 box with pressure gauge
4 air tank
5 cabinet
A 2024
- After removing the tower 1, it is advised to
place it in a horizontal position to prevent it
from falling and getting damaged.
- Take off the side cover.
- Insert the air hose G fi g.2 into hole A behind
the tower tilt cylinder.
- Assemble the tower 1, insert pin B into hole C
and lock with screw and washer D.
- Insert pin E into hole F and into U-bolt F1 on
the tower tilt cylinder and lock with ring M.
- Connect hose G to the intermediate connection
linked to the tower-lifting cock H.
- Fit the box with pressure gauge 3 on to the
tower 1 and lock with screw and washer S.
- Fit the tower guard 2 and lock with screws and
washers L.
- Insert the tank 4 outlet into hose Q. Fix the tank
4 to the machine with nuts and washers R and
tighten clamp O on hose Q (T.I. version only).
- Open the bead break arm Z.
- Insert the spacer pad U on to the bead break
cylinder pin V, re-close the bead break arm
by passing the bead break cylinder pin back
through the adjustable outlet.
- Nut T is to be screwed on to bead break cylinder
pin V only when the machine is installed and
hooked up to the compressed air line.
Tighten nut T until P is 3-4 mm.
Operator's manual MTS 20" - MTS 24" - A 2024
MTS 20" - MTS 24"
- After removing the tower 1, it is advised to
place it in a horizontal position to prevent it
from falling and getting damaged.
- Take off the side cover.
- Insert the air hose G fi g.2 into hole A behind
the tower tilt cylinder.
- Fit screw B into hole C and lock with nut and
washer D.
- Insert pin E into hole F and into U-bolt F1 on
the tower tilt cylinder and lock with snap-ring
M.
- Connect hose G to the intermediate connection
linked to the tower-lifting cock.
- Fit the tower guard 2 and lock with screws and
washers L.
- Fit the side cover.
HOISTING / MOVING
To remove the machine from the pallet, sling it
as shown in fi gure 3.
This lifting point must be used whenever you
need to change the position of the machine.
Do not attempt to move the machine until it
has been disconnected from the electrical and
air networks.
INSTALLATION
CLEARANCES
WARNING
Choose the place of installation in strict observ-
ance of local regulations regarding safety in
the workplace.
IMPORTANT: for correct, safe use of the equip-
ment, users must ensure a lighting level of at
least 300 lux in the place of use.
ATTENTION
If the machine is to be installed outdoors,
it must be properly protected from adverse
weather by a roof.
Place the tyre changer in the designated work
position observing the minimum clearances
shown in fi gure 4.
EN
21