Descargar Imprimir esta página

Signature Kitchen Suite SKSCR2401P Manual Del Propietário página 31

Refrigerador incorporado
Ocultar thumbs Ver también para SKSCR2401P:

Publicidad

Idiomas disponibles

Idiomas disponibles

en-us_main.book.book Page 31 Thursday, June 29, 2023 10:56 AM
Water
Problem
Water is dispensing
Water filter has been exhausted.
slowly.
• Replacing the water filter is recommended:
Reverse osmosis filtration system is used.
• Reverse osmosis filtration systems can reduce the water pressure below the minimum
Low house water supply pressure.
• The water pressure must be between 20 and 120 psi on models without a water filter and
Water is not
New installation or water line recently connected.
dispensing.
• Dispense 2.5 gallons of water (flush for approximately 5 minutes) to remove trapped air
Refrigerator or freezer doors are not closed properly.
• Water will not dispense if any of the refrigerator doors are left open.
Water filter has been recently removed or replaced.
• After the water filter is replaced, dispense 2.5 gallons of water (flush for approximately five
Tubing connecting refrigerator to house supply valve is kinked.
• The tubing can kink when the refrigerator is moved during installation or cleaning,
The house water supply is not connected, the valve is not turned on fully, or the valve is
clogged.
• Connect the refrigerator to the water supply and turn the water shutoff valve fully open. If
Dispensing warm
Refrigerator was recently installed.
water.
• Allow 24 hours after installation for the water storage tank to cool completely.
The water dispenser has been used recently and the storage tank was exhausted.
• Depending on your specific model, the water storage capacity will range from
Dispenser has not been used for several hours.
• If the dispenser has not been used for several hours, the first glass dispensed may be
Refrigerator is connected to the hot water supply.
• Make sure that the refrigerator is connected to a cold water pipe.
- Approximately every six months.
- When the water filter indicator turns on.
- When the water dispenser output decreases.
- When the ice cubes are smaller than normal.
amount and result in icemaker issues. If the problem persists, it may be necessary to
contact a plumber.
between 40 and 120 psi on models with a water filter. If the problem persists, it may be
necessary to contact a plumber.
and contaminants from the system. Do not dispense the entire 2.5 gallon amount
continuously. Depress and release the dispenser pad for cycles of 30 seconds ON and 60
seconds OFF.
minutes) to remove trapped air and contaminants from the system. Do not dispense the
entire 2.5 gallon amount continuously. Depress and release the dispenser pad for cycles of
30 seconds ON and 60 seconds OFF.
resulting in reduced water flow. Straighten or repair the water supply line and arrange it to
prevent future kinks.
the problem persists, it may be necessary to contact a plumber.
approximately 20 to 30 oz.
warm. Discard the first 10oz.
WARNING: Connecting the refrigerator to a hot water line may damage the
icemaker.
TROUBLESHOOTING
Possible Cause & Solution
31

Publicidad

loading

Este manual también es adecuado para:

Skscr3001p