Service Menu; Configuring Interfaces; Searching And Installing A Wi-Fi Interface - Hella Gutmann SEG V Manual Del Usuario

Hella Gutmann
1. Select Settings > Update in the main menu.
CAUTION!
Insufficient voltage supply
System data loss
Do not switch off the device during the update and do not disconnect it from voltage supply.
Ensure sufficient voltage supply.
2. Start the update with
The device searches for a new update, the files will then be downloaded and installed.
ð The device switches off and on again automatically after the successful software update.

7.8. Service menu

The >Service menu< is exclusively reserved for Hella Gutmann service technicians or the testing organizations.

7.9. Configuring interfaces

Make your Wi-Fi and e-mail settings here.
Wi-Fi is a wireless local area network. Data is transmitted wirelessly via a router and DSL modem (access point). The re-
spective devices register in the Wi-Fi router.

7.9.1. Searching and Installing a Wi-Fi Interface

Proceed as follows to connect the device to a network (router) via Wi-Fi interface:
1. Select Settings > Device > Interfaces > Network in the main menu.
2. Open the list under IP address mode with
If >Determine automatically (DHCP)< (recommended) is selected, the DHCP server of the network will assign an IP
address to the SEG V automatically. This option is set ex works.
If >Manual< is selected, then go to SEG V – IP address and enter a free IP network address, e.g.: Network mask
192.168.246.002 / Standard gateway: 192.168.204.2.
3. Select >Determine automatically (DHCP)< (recommended) or >Determine manually<.
The selection will be saved automatically.
4. Create wireless network with
The Wi-Fi connection search is active.
Once the device has successfully finished the search for a Wi-Fi connection, a drop-down list of Wi-Fi networks found is
displayed.
5. Select a Wi-Fi network.
6. Confirm the selection with
SEG V
.
.
.
.
Device configuration | 7.
111