Hella Gutmann
4. Abort the procedure with
5. If required, change the data as described in the section Configuring Vehicle Data [} 102].
The headlight setting data shall correspond to the manufacturer's specifications.
6. Open the Headlight selection window with
7. Perform the headlight test as described in the section Performing headlight test [} 135].
8. Finish the measurements with
An info window indicates that the results are being sent to the asanetwork DMS.
9. Confirm the selection with
The window closes and the main menu appears again.
10. Abort the procedure with
ð In the DMS software the order is indicated as done now. The results are listed in the corresponding protocol.
SEG V
.
.
.
.
.
Device configuration | 7.
115