Air Intake Screen; General Cleaning And Tightening; Storage - K-JAPAN KJRH300 Manual Del Propietário

ENGINE SCREEN
Maintenance Interval
The screen should be cleaned and inspected each
time the Handheld Blower is used.
Screen Cleaning
Clean all dirt and debris from the screen.

AIR INTAKE SCREEN

Maintenance Interval
The air intake screen should be cleaned and inspected
each time Handheld Blower is used and when air flow
dropped down during operation.
Air Intake Screen Cleaning
Clean all dirt and debris from the air intake screen.
WARNING !
Never use the Hand-held Blower without the
air intake screen. Before starting the engine, check the
screw is securety tightend and no damage.

GENERAL CLEANING AND TIGHTENING

CAUTION: When engine is running, fan is rotating and other parts are moving. Contact
with rotating fan or other moving parts could cause serious personal injury or death.
Always turn off your Handheld Blower before you clean or perform any maintenance on
it.
The Maruyama Handheld Blower will provide maximum performance for many, many hours if it is
maintained properly. Good maintenance includes regular checking of all fasteners for correct
tightness, and cleaning the entire machine.
For long term storage of the Handheld Blower :
1. Empty the fuel tank into a suitable fuel storage container
approved for gasoline.
2. Pump the primer bulb on the carburetor until all fuel is
discharged through the clear fuel return hose.
3. Run the engine to remove any fuel that may remain in
the carburetor.
4. Perform all regular maintenance procedures and any
needed repairs.
5. Remove the spark plug and squirt a very small amount
of oil into the cylinder.
6. Pull the starter grip once.
7. Slowly pull the starter grip to bring the piston to the top of the cylinder (TDC).
8. Reinstall the spark plug.
9. Store the Handheld Blower in a dry place away from excessive heat, sparks or open flame.
CAUTION: Oil may squirt out of the spark plug opening when you pull the starter grip. Oil
can cause eye injuries. Protect your eyes and keep your face away from the spark plug
opening.
English

STORAGE

— 11 —
Screen
Screw
3mm
Allen Wrench
Air Intake Screen