To Stop The Engine; Carburetor Adjustment - K-JAPAN KJRH300 Manual Del Propietário

HOT RESTART
To start the engine that is already warmed up (hot restart), or if the ambient temperature exceeds
20°C:
1. Pump the primer bulb at the bottom of the carburetor until fuel can be seen flowing through
the fuel return line to the fuel tank.
2. Move the choke lever to the ( ) position and move the stop switch to the "ON" position.
3. More the throttle setting lever to the idle position and pull the starter grip.
4. If the engine fails to start after three to four pulls, follow the instruction in the Cold Starting
Procedure section (page 7).
If the engine fails to start after you follow the above procedures, contact an authorized
Maruyama dealer.
Note : 1. Don't pull the starter cord out completely.
2. Do not rerease the starter cord from the fully extended position.
Indication of the sound power levels :
The values in the owner's/operator's manual indicate measured sound power level. The
values in the EC declaration of conformity indicate guaranteed sound power level.

TO STOP THE ENGINE

1. Move the throttle setting lever to the idle position. Release the throttle trigger.
2. Slide the stop switch to the "STOP" position.

CARBURETOR ADJUSTMENT

This Handheld Blower is equipped with non-adjustable fuel mixture carburetor. The engine idle
speed is the only adjustment for the operator.
WARNING ! Idle speed adjustment should be checked each time the unit is operated.
WARNING ! Engine must be running to make carburetor adjustments. When engine is running,
fan is rotating and other parts are moving. Contact with rotating fan or other moving parts could
cause serious personal injury or death. Keep hands, feet and clothing away from fan and other
moving parts. Keep all bystanders and pets away from unit while making carburetor adjustments.
Wear the recommended personal protective equipment and observe all safety instructions.
Engine Idle Speed :
When the throttle trigger and the throttle setting lever is idle position the engine should return to an
idle speed between 2700 and 3300 RPM. The engine should not stall (stop running) at engine idle
speed.
To adjust the engine idle speed, rotate the
idle speed adjustment screw on the
carburetor.
• Turn the idle speed screw in (clockwise)
to increase the engine idle speed.
• Turn the screw out (counterclockwise) to
decrease the engine idle speed.
If idle speed adjustment is necessary,
and after adjustment the engine stalls,
s t o p u s i n g t h e H a n d h e l d B l o w e r
immediately!
Contact your local authorized Maruyama Dealer for assistance and servicing.
Idle Speed
Adjuster Screw
— 8 —
English