Remote Control Device Installation - TOHATSU MD 30B2 Manual Del Propietário

30
INSTALLATION
75, 90, 115
1
5
1. Bolt (12 mm × length 105 mm)
2. Washer (large diameter)
3. Nut
4. Washer (small diameter)
ø13
(0.5")
1. Top of transom
ENOW00008-A
Mounting bolts should be installed with
the bolt head at inside surface of the
transom. Mounting bolts installed with
the threaded end at the inside surface of
the transom can cause personal injury.
Tighten the bolts sufficiency, otherwise
falling down of outboard could be hap-
pened.
2
3
4
ENOF00614-0
327
(12.9")
51 (2")
17.5 (0.7")
17.5 (0.7")
17.5 (0.7")
251
(9.9")
ENOF00615-0
CAUTION
ENON00003-0
Notes
1. Apply sealing agent, such as silicone
sealed between the bolts and the tran-
som board holes before tightening the
bolts.
2. Be sure to tighten the mounting bolt
nuts to the specified torque.
(30 Nm (3.0 kgf) 13 ft-lb)
ENOM00840-0
2. Remote control device
installation
ENOW00850-0
Remote control box location
1
Install the remote control box in a position
where it is easy to reach and operate the
controls.
Make sure there are no obstacles that can
interfere with the operation of the remote
control cable.
1. Shift cable
2. Throttle cable
3. Cable harness B
3
1, 2
ENOF00841-0