Fuel Feeding; Starting The Engine - TOHATSU MD 30B2 Manual Del Propietário

ENOM00044-B

2. Fuel feeding

ENOW00029-A
WARNING
When opening fuel tank cap, be sure to fol-
low the procedure described below. Fuel
could blast out through the fuel tank cap in
case the cap is loosened by using another
procedure when internal pressure of fuel
tank is raised by heat from sources such as
sun light.
1. Full open the air vent screw on the fuel
tank cap.
1. Air vent screw
2. Fuel tank cap
2. Connect the fuel connector to the
engine and fuel tank.
2 2
1. Fuel connector
2. Pull
3. Insert
1
2
ENOF00027-A
3 3
1
ENOF01316-0
ENGINE OPERATION
1
1. Pull
2. Insert
3. Squeeze primer bulb until it becomes
stiff to feed fuel to vapor separator.
Direct arrow mark upward when prim-
ing.
1
2
1. Engine side
2. Fuel tank side
Do not squeeze primer bulb with engine
running or when the outboard motor is
tilted up. Otherwise, fuel could overflow.
ENOM00045-A

3. Starting the engine

ENOW00036-A
CAUTION
When the engine is started in the test tank,
to avoid over heating and water pump
damage, be sure the water level is at least
10 cm (4 in.) above the anti ventilation
plate.
And be sure to remove the propeller, when
starting the engine in the test tank. (See
page 79)
Run the engine only at idling.
45
2
ENOF00861-A
ENOF00862-0
7