TOHATSU MD 30B2 Manual Del Propietário página 61

ENOW00056-A
WARNING
When tilting up outboard motor with fuel
joint for over a few minutes, be sure to dis-
connect fuel hose, or fuel may leak, poten-
tially catching fire.
ENOW00057-0
CAUTION
Do not tilt up outboard motor while engine
operates, or no cooling water may be fed,
leading to engine seizure due to overheat-
ing.
ENON00921-0
Note
Before tilting the outboard motor up, after
stopping the motor leave it in the running
position for about a minute to allow water to
drain from inside the engine.
ENOM00062-A
Manual Tilt type (*30, 40, 50 only)
Tilt up
Push the reverse lock lever down until it
stops. (This is the tilt up position.) Now, tilt
the outboard motor all the way up until it is
locked in place.
1
2
3
1. Reverse lock lever
2. Tilt up position
3. Tilt down position
ENOM00063-0
Tilt down
Pull the reverse lock lever upward until it
stops. (This is the tilt down position.) Now,
lift up the outboard motor slightly, and then
allow gravity to lower it for you.
1. Reverse lock lever
2. Tilt up position
3. Tilt down position
ENOM00069-A
Power Trim & Tilt type
Tilt up
1. Operate the Power Trim & Tilt switch
and tilt the outboard motor up.
2. Lock the tilt with the Tilt stopper after
the outboard motor has been tilted up
Tilt down
ENOF00059-0
1. Release the tilt stopper from the set-up
position while slightly tilting up out-
board motor.
ENGINE OPERATION
ENOF01317-0
1
2
3
ENOF00059-0
59
7