Engine Operation; Before Starting; Engine Oil Feeding - TOHATSU MD 30B2 Manual Del Propietário

ENGINE OPERATION

ENOM00042-0

Before starting

ENOW00022-A
CAUTION
The engine oil is drained for shipping from
the factory. Be sure to fill the engine to the
proper level before starting engine. (To
properly fill the engine with oil follow the
instructions. See page 62)
1
3
1. Genuine of recommended engine oil
2. Filler lid
3. Oil tank cap
ENOW00027-A
CAUTION
Before starting engine for the first time
after reassembling engine or off-season
storage, disconnect stop switch lock and
crank approximately 10 times in order to
prime the oil pump.
ENOM00656-A

1. Engine oil feeding

When the engine is new or have been left
without operation for a long time, or just
after the engine is overhauled, be sure to
execute the following operation for forc-
edly feeding the engine oil to the oil line
before starting the engine.
ENOM00657-0
30, 40, 50 type
a. Disconnect the link rod by turning the
b. Make sure that the oil pump control
c. Idle the engine for more than 30 min-
2
d. Reset the link rod to the advancer arm.
30, 40, 50
ENOF00641-0
1. Rod snap
2. Link rod
3. Advancer arm
4. Cable joint
5. Throttle cable
6. R shaped pin
7. Nut
rod snap interlocking with the oil pump
as shown in the figure.
lever is set at open side position.
utes.
1
2
3
7
6
43
7
4
5
ENOF00651-0