Square Buttonhole; To Sew - Janome Hello Kitty 18750 Manual De Instrucciones

w e
q
z
q
x
e
r
c
t
v
y
u

Square Buttonhole

r
Machine setting
q Stitch pattern:
w Needle thread tension: 1 to 5
e Presser foot:
r Buttonhole lever sign

• To sew

z Press the needle up/down button to raise the needle.
w
x Pull the button holder e to the back, and place the
NOTE:
If the button is extremely thick, make a test buttonhole
on an extra piece of the fabric.
If it is difficult to fit the button through the test
buttonhole, you can lengthen the buttonhole by pulling
the button holder back a little. The length of the
buttonhole will be increased.
c Pull the buttonhole lever t down as far as it will go.
v Insert the corner of the fabric under the foot.
i
!0
o
NOTE:
Make sure there is no gap !0 between the slider and
stopper, otherwise the buttonhole will not be sewn in
the required position.
!1
u
64
Attach the automatic buttonhole foot R snapping
the pin w into the slit q of the foot holder.
q Slit
w Pin
button in it. Push it together tightly to the button.
e Button holder
r Extra gap
t Buttonhole Lever
Press the needle up/down button twice.
Remove the fabric to the left to draw the needle
thread through the hole of the foot.
Place the fabric under the foot, and lower the
needle at the starting point of the buttonhole mark y.
Then lower the automatic buttonhole foot R.
y Buttonhole mark
u Starting point
i Slider
o Stopper
!0 No gap
!1 Sewing gap
05
Automatic buttonhole foot: R